Has anybody found a good one? I've heard of Pretty Printer from Aardvark Software but it's pretty pricey. I don't mind paying but I'd like to know a little more about it before I buy. Any suggestions or recommendations?

Well,  I suppose what's good depends on exactly what you're looking for, but ... I use Code.Print from Caladonia Systems (www.caladonia.com). There's a lot of flexibility in terms of what you print, and you have a fair amount of control over the fonts, headers, and so on. And it's inexpensive. The only problem I've had with it is that it occasionally pukes if the printer isn't fully ready to print at the time you start. For instance, we have a HP 4SIMX that automatically goes into a power-save mode when it hasn't been used in 30 minutes or so. It takes it about a minute to warm up afterwards. If I start printing while it's in power-save, CP may puke and either print garbage, or nothing at all. Aside from that annoyance, it's a good value.

Has anybody found a good one? I've heard of Pretty Printer from Aardvark Software but it's pretty pricey. I don't mind paying but I'd like to know a little more about it before I buy. Any suggestions or recommendations?  I have used it before, it is not too bad, but it has it's limitations. Sometimes it craps itself when the file is close to the 64k limit. It also will only load one file at a time, not an entire project. Also you can not export it to any other formats. All in all it is OK for small jobs, but at about $100 it is OK I guess Neil Macdonald